Inertial supercharger system for URAL/DNEPR motorcycle |
Inertial supercharger system made by IMZ. This system may save up to 18% gas in urban cycle and 12% off-road. Rise power and acceleration bike's engine without downer reliability. System forbid condense fuel-air in carb and intake port. It use flow's inertia in left cylinder for right cylinder and inversely. On 1100 RPM power with system up on 4 hp, on 2000 RPM power up on 3 ph than without system. On more high RPM powers is equal. See graph. Include:
|
How install? |
We get many questions about install this system. Install easy. We install it to our friend's Ural bike for simple. We take one half hour for it. You need two 13-14mm spanner
and hammer. |
|
Step 1.Undo two nut and dismount carburettor. Save gasket! |
Step 2.Lock a nuts on stud use two spanner (We have only one spanner and use flat-nosed pilers) |
Step 3. When you lock nuts, you can dismount old short studs. |
Step 4. Mount new long studs. Attention:Thread pitch different in one and two side of stud. You must install side with big thread pitch into head. |
Step 5. Mount collector on new studs. You can light bang by hammer via wood's billet |
Step 6. Set new gasket. |
Step 7. Fix hosepipe via yoke. |
Step 8.Mount carburettor into collector |
Step 9. Cross hosepipe between alternator and air's filter. Mount second collector into other side. |
Step10. When you mount both collectors and start - engine pick up speed. You must adjust idle.Use two screw - see red cursors. |