|
Inertial supercharger system for URAL DNEPR K-750 motorcycles |
Introduction
This inertial system may save up to 18% gas in urban cycle and 12% off-road. Rise power and acceleration bike's engine without downer reliability. System forbid condense fuel-air in carb and intake port. It use flow's inertia in left cylinder for right cylinder and inversely.
On 1100 RPM power with system up on 4 hp, on 2000 RPM power up on 3 ph than without system. On more high RPM powers is equal. See graph:
How to install an inertial supercharger system for URAL DNEPR K-750 motorcycles?
We get many customer requests about installation process of inertial system. It's easy! The entire installation process takes no more than half hour! You need two 13-14mm spanner and hammer.
|
|
Step 1. Undo two nuts and dismount carburettor. Save a gasket!
|
Step 2. Lock two nuts on stud using two spanner (or one spanner and flat-nosed pliers).
|
|
|
Step 3. When two nuts were locked, you can dismount old short studs.
|
Step 4. Mount new long studs.
|
|
|
Step 5. Mount collector on new studs.
|
Step 6. Mount new gasket.
|
|
|
Step 7. Fix hose pipe yoke.
|
Step 8. Mount carburettor on collector.
|
|
|
Step 9. Pull hose pipe between the generator and the air filter. Mount the second collector.
|
Step10. When both collectors were mounted you can start engine. Adjust carburetors if necessary!
|
|
|
|