Shipping info Payment info How to order Privacy notice Return policy Contact us
CURRENCY
YOUR CART IS EMPTY
Checkout
CATEGORIES
Engine & Components
Clutch
Gearbox
Final drive
Wheel, brake
Front Fork
Frame, rear fender
Fuel tank
Controls
Exhaust
Seats, Saddles
Intake
Accessories
Electrical components
Sidecar accessories
Shock absorber
Gears & Bearings
Gaskets & Seals
Wholesales & Sets
Manuals & Literature
BESTSELLERS
Cylinder gasket (paranite) URAL - $0.99/ea In Stock

Cylinder head gasket (aluminum) URAL 650cc - $0.99/ea In Stock

Carburetor paronite gaskets 1mm thickness (set of 2pc.) URAL DNEPR - $0.79/ea In Stock

Cylinder head gasket (PARANITE) URAL 650cc - $0.99/ea In Stock

Wheel spoke (short) with nipple URAL - $0.99/ea In Stock

Oil filter URAL - $1.99/ea In Stock

Valve key URAL 650cc - $0.49/ea In Stock
ARTICLES
IMZ-URAL motorcycles history
KMZ-Dnepr motorcycles history
How to ride URAL motorcycle?
Adjustment and repair K65T carburetors
Inertial supercharger system URAL DNEPR
How to shorten a cable on a motorcycle?
How to longer a cable on a motorcycle?
Inertial supercharger system for URAL DNEPR K-750 motorcycles

Introduction

This inertial system may save up to 18% gas in urban cycle and 12% off-road. Rise power and acceleration bike's engine without downer reliability. System forbid condense fuel-air in carb and intake port. It use flow's inertia in left cylinder for right cylinder and inversely.

On 1100 RPM power with system up on 4 hp, on 2000 RPM power up on 3 ph than without system. On more high RPM powers is equal. See graph:

How to install an inertial supercharger system for URAL DNEPR K-750 motorcycles?

We get many customer requests about installation process of inertial system. It's easy! The entire installation process takes no more than half hour! You need two 13-14mm spanner and hammer.
Step 1. Undo two nuts and dismount carburettor. Save a gasket! Step 2. Lock two nuts on stud using two spanner (or one spanner and flat-nosed pliers).
Step 3. When two nuts were locked, you can dismount old short studs. Step 4. Mount new long studs.
Step 5. Mount collector on new studs. Step 6. Mount new gasket.
Step 7. Fix hose pipe yoke. Step 8. Mount carburettor on collector.
Step 9. Pull hose pipe between the generator and the air filter. Mount the second collector. Step10. When both collectors were mounted you can start engine. Adjust carburetors if necessary!
Copyright 2006-2018 RussianGarage Inc. All rights reserved.