Shipping info Payment info How to order Privacy notice Return policy Contact us
Engine & Components
Final drive
Wheel, brake
Front fork
Frame, Rear swing arm
Fuel tank
Seats, Saddles
Intake, Carburetor
Electrical components
Sidecar accessories
Shock absorber
Gears & Bearings
Gaskets & Seals
Wholesales & Sets
Manuals & Literature
Carburetor paronite gaskets 1mm thickness (set of 2pc.) URAL DNEPR - $0.79/ea In Stock

Kit of paronite gaskets for complete engine repair URAL 650cc - $7.99/ea In Stock

Cylinder gasket (paper) URAL 650cc - $0.29/ea In Stock

Oil sump gasket (rubber) URAL - $1.99/ea In Stock

Repair manual URAL DNEPR - $7.99/ea In Stock

Oil filter (high quality) with bushing URAL - $3.49/ea In Stock

Rubber footrest (driver, passenger) URAL DNEPR K-750 - $3.49/ea In Stock
IMZ-URAL motorcycles history
KMZ-Dnepr motorcycles history
How to ride URAL motorcycle?
Adjustment and repair K65T carburetors
Inertial supercharger system URAL DNEPR
How to shorten a cable on a motorcycle?
How to longer a cable on a motorcycle?
Oil seals for URAL and their analogues
Inertial supercharger system for URAL DNEPR K-750 motorcycles


This inertial system may save up to 18% gas in urban cycle and 12% off-road. Rise power and acceleration bike's engine without downer reliability. System forbid condense fuel-air in carb and intake port. It use flow's inertia in left cylinder for right cylinder and inversely.

On 1100 RPM power with system up on 4 hp, on 2000 RPM power up on 3 ph than without system. On more high RPM powers is equal. See graph:

How to install an inertial supercharger system for URAL DNEPR K-750 motorcycles?

We get many customer requests about installation process of inertial system. It's easy! The entire installation process takes no more than half hour! You need two 13-14mm spanner and hammer.
Step 1. Undo two nuts and dismount carburettor. Save a gasket! Step 2. Lock two nuts on stud using two spanner (or one spanner and flat-nosed pliers).
Step 3. When two nuts were locked, you can dismount old short studs. Step 4. Mount new long studs.
Step 5. Mount collector on new studs. Step 6. Mount new gasket.
Step 7. Fix hose pipe yoke. Step 8. Mount carburettor on collector.
Step 9. Pull hose pipe between the generator and the air filter. Mount the second collector. Step10. When both collectors were mounted you can start engine. Adjust carburetors if necessary!
Copyright 2006-2021 RussianGarage Inc. All rights reserved.